news

The fastest way to adjust the mold of a die-cutting machine

Date:2025-07-21 13:26:16    Views:11

1.  Connect the power supply and check the equipment. Test the machine for a few minutes before setting up the mold to ensure its normal operation! When the die-cutting machine and the continuous machine are punching products, the die-cutting die must be placed straight; otherwise, the punched products are prone to material shortage. Remove the template from the machine and place it on the workbench. Stick the mold with tape and place it horizontally straight above the template to stick it firmly.
2.  After installing the template, tighten the screws on the right or left side and increase the pressure to ensure that the gap between the upper and lower templates is higher than the thickness of the mold plus the PC board. Fix the lower part of the mold with a PC board and tape on it. Use white paper with tape on it and stick it on the other side of the PC board without tape. The PC board is at the bottom and the white paper is in the middle. After placing the carbon paper, gradually reduce the pressure. Use the main unit to press in and test the pressure slowly until the entire die is covered on the white paper.
3.  The marks on the white paper are for facilitating the confirmation of the debugging position when printing the product. Place the paper under the PC board and position it with positioning foam. Place the materials properly and conduct a test die, remove the waste materials, and inspect the products. If you find that the products are not broken or have burrs, take out the paper placed under the PC board and stick transparent tape on the corresponding defective areas.
    If delamination or over-cutting of the product is found, a blade should be used to gently scrape the poorly aligned areas of the PC board. After the product trial adjustment is completed, the frame material should be set with the jump distance, etc. The first mold product that has been debugged should be confirmed by the quality control department. Only after the quality control department confirms it can the punching process be carried out.
https://www.labeldiecutter.com/productdetail/double-unit-label-die-cutting-and-hot-stamping-machine-.html